+- KernelClankers (https://kernelclankers.org)
+-- Forum: Projects & Builds (https://kernelclankers.org/forumdisplay.php?fid=6)
+--- Forum: Show Your Prints (https://kernelclankers.org/forumdisplay.php?fid=22)
+--- Thread: My first successful print on Linux – Raspberry Pi case (/showthread.php?tid=14)
My first successful print on Linux – Raspberry Pi case - WL7JA - 4 April 2026
Here's my first decent print done entirely on Linux using Orca Slicer.
It's a simple but sturdy case for my Raspberry Pi 5. Printed in PLA, 0.2mm layer height, no supports needed.
What do you think? Any suggestions for improvements?
[Attach a photo of the print here]